You Have Been "BOO'ED" Treat Door Hanger

Over on The Little Blue House blog they have a Trick or Treat October Blog Series going on and with prizes too! Make sure to stop on by their blog for tons of inspirational Halloween ideas. 

For my first project, I created this fun treat door hanger using the Carta Bella Trick or Treat Collection. It was super easy to make, see how below.

1. Using a 12x12 piece of paper, roll it into a cone and adhere it with a quick drying glue. I used a hot glue gun.

2. Trim the top of the cone so it's even. Cut two small circles from a scrap piece of cardstock glue them onto the sides of the cone at the top and punch a hole in each side. Then using a piece of wire connect it to each side of the cone.

3. Hot glue a piece of ribbon around the top part of the cone, scrunching it up slightly so it has a ruffled effect.

 4. Take about a 6 inch piece of ribbon and fold in half. Cut up into the folded ribbon creating strips leave about a half inch uncut at the folded area of the ribbon.

5. Roll the ribbon piece up and glue into the end of the cone.

6. Embellish as desired, and add some yummy treats.

Thanks for looking and happy crafting!